Installation Procedures for Siglite Glass Road Studs Serious
- Road safety Devices.
- Use drill stop on the drilling bit to drill hole (Diameter: 100mm, Depth: 25mm)
- Use hammer and chisel to remove the asphalt or concrete debris in the hole.
- Use high pressure air blower to blow away the sand and water in the holes. Or use sponge to absorb the water
- Use depth gauge to test the proper depth of holes. Modification may required to if too deep or too shallow.
- Use epoxy or asphalt adhesive to fasten reflector. Asphalt adhesive is suggested for installation on freeways or high traffic areas or for larger road projects, because it is cost and time effective. Epoxy is suggested for minor or trivial road works.
- Place Siglite road stud in the hole and turn about 30 degrees. Use a rubber hammer to secure the position by gently pounding the glass dome.